Skip to content

Abnormal Load Escorts, Flags and Warning Lights: What the Permit Requires

Updated 7 min read

Abnormal load on a lowbed with red corner flags and an escort vehicle following behind on a South African national road

A permit does not just say yes. It attaches conditions — escorts, flags, lights, boards, speed limits — and those conditions are the real cost of moving an abnormal load. The useful thing is that you can work most of them out before you apply.

It comes down to three numbers: how big your load is, what road it is using, and how those two combine. Everything below is from TRH 11, the South African standard for abnormal load vehicles.

Step 1 — your load has a class

Abnormal loads are classified twice: once on dimensions, once on mass. Dimension class is set by whichever of width or length puts you in the higher band.

Dimension classMaximum widthMaximum length
D12,75 m27 m
D23,00 m30 m
D33,25 m34 m
D43,75 m40 m
D54,75 m54 m
D6> 4,75 m> 54 m
TRH 11 Table 1.1, Classification According to Dimensions.
Mass classMaximum laden mass
M160 t
M265 t
M380 t
M4100 t
M5125 t
M6> 125 t
TRH 11 Table 1.2, Classification According to Mass. Based on the laden mass.

For perspective: an ordinary legal combination is 2,6 m wide and up to 22 m long. D1 begins just 150 mm wider than legal — abnormal status arrives sooner than most people expect.

Step 2 — your route has a category

Roads are classified A to D on paved width and posted speed limit. A category A road is at least 18 m wide; a category D road is under 10 m, or 10–13 m at under 100 km/h. The full table is on the abnormal, bulk and special loads page.

Step 3 — the two together give your escort

ClassRoute ARoute BRoute CRoute D
D1No escortNo escortNo escortNo escort
D2No escortNo escortNo escort1 own escort
D3No escortNo escort1 own escort2 own escorts
D4No escort1 own escort2 own escorts2 traffic officer
D51 own escort2 own escorts2 traffic officer2 traffic officer
D62 traffic officer2 traffic officer2 traffic officer2 traffic officer
TRH 11 Table 4.2, Escort Requirements for Wide and Long Loads in terms of Dimension Class and Route Category.

Read that matrix across a row and you have the whole argument for route planning. A D4 load needs no escort at all on a category A road, one own escort on a B, two on a C, and two traffic officer escorts on a D. Same load, same truck, four different costs — decided entirely by the road.

Read down a column instead and you see where the step changes are. On a category D road, escorts start at D2; on a category A road, not until D5.

When there is no route category

Where a route has not been categorised, TRH 11 falls back to a calculated Road Usage Factor:

RUFEscorts required
RUF ≤ 0,54None
0,54 < RUF ≤ 0,94One own escort vehicle
0,94 < RUF ≤ 2,73Two own escort vehicles
RUF > 2,73Two traffic officer escorts, or one traffic officer plus one own escort
TRH 11 Table 4.3. The RUF formula is given in §7.3 of the standard.

What an escort actually is

Own escort — you provide it

A single own escort travels BEHIND the abnormal vehicle — between 10 m and 50 m, as far back as possible while still in sight, so other traffic gets warning while normal overtaking stays possible.

The exception is worth knowing, because it is the one people get wrong: the escort travels in front when the abnormality is an excessive front overhang, or when a height gauge is prescribed for loads exceeding 4,7 m. Where two own escorts are specified, one goes in front and one behind, both at 10–50 m.

Traffic officer escort — the authorities provide it

Provided by the road traffic authorities and normally two vehicles. At the permit office’s discretion, one may be replaced by an own escort vehicle. This is the expensive end of the table, and it is where a D6 load sits on every route category.

Warning apparatus

Flags

The extremities of the vehicle or load must carry bright red flags showing its overall length and width. Each must be securely attached, placed at the extreme corners, measure at least 600 mm × 600 mm, and be “clean and free to flutter.”

That last phrase is not decoration — a flag wrapped around its own staff is not doing the job it is there for.

What else, and when

Road Usage FactorWarning apparatus required
RUF < 0,54Flags · abnormal vehicle warning board
RUF ≥ 0,54Flags · abnormal vehicle warning board · amber flashing lights · marker lamps and retro-reflectors
TRH 11 Table 4.1, Warning Apparatus Requirements for Long and Wide Loads.

Projections, night travel and slow loads

TRH 11 also prohibits warning apparatus when the vehicle is not operating under a permit that requires it. The kit comes off when the load does.

Working it out before you apply

  1. Measure the loaded vehicle — overall width and overall length, including projections.
  2. Find your dimension class in Table 1.1, and your mass class in Table 1.2.
  3. Categorise the route — paved width and posted speed.
  4. Read the escort requirement off the matrix.
  5. Price it. Two traffic officer escorts is a different job from no escort, and it is the same load either way.
  6. Then look for an alternative route, because step 5 is often cheaper to solve with a map than with a budget.

Questions people ask

Does an escort vehicle drive in front or behind?
A single own escort travels behind, between 10 m and 50 m, as far back as possible while remaining in sight. It moves to the front only when the abnormality is an excessive front overhang, or when a height gauge is prescribed for loads over 4,7 m. With two own escorts, one goes in front and one behind.

What vehicle can be used as an own escort?
A passenger car or light motor vehicle with a GVM not exceeding 3 500 kg, fitted with an amber flashing light and an abnormal vehicle warning board on the roof, visible from all directions.

How big must abnormal load flags be?
At least 600 mm × 600 mm, bright red, at the extreme corners of the vehicle or load, securely attached, clean and free to flutter.

When do I need traffic officer escorts?
From dimension class D4 on a category D road, D5 on category C, and every route category at D6. Under the RUF method, when the RUF exceeds 2,73.

Do flags apply to a rear projection?
Yes. Regulation 229 requires projections beyond the legal limits to be flagged, and a load projecting more than 1,8 m beyond the rear needs flags on each side at the end of the projection.

Where this comes from

The permit office has the final word. These tables are what the standard specifies; a permit can attach conditions beyond them for a particular route, structure or time of day. Work them out to plan and to price — then confirm with the authority issuing your permit.

Next

Kweli Load Exchange

Now find a load for your truck — or a truck for your load

Free for transporters and shippers. No commission, no subscription.

Local

and cross-border

See

who you are dealing with

R0

commission, always

List your truck and its corridors, or post a load. Your corridors decide which loads we show you first — they do not lock you out of the rest. Body, weight, fit, papers: we show them, and you decide.

WhatsApp-integrated · your number is your account. Nothing from an app store — you finish with your trucks and their corridors on the board.

New to Kweli? See what the network does → — load exchange, driver registry and the Pulse community.

Share the Post: WhatsApp LinkedIn X
Find loads for your truckFree to join · no booking feesOpen